Craft a remote relay | 6: Repair to Ride Dead Space 3 Guide

Last update: 11 May 2016

After getting to the Aft Station, go to the elevator on the right. After you call it, few Necromorphs will attack you. If you have a torque bar, you can go to the door on the left - in a small room you'll find ammo and other useful resources.

Audio Logs 1/1 - You'll find it in the Mid Station, inside the control room on the left (you have to restore the power first).

After riding the elevator down, you'll see a huge shuttle. In order to release it, you have to start it first. The first step to do this is creating a remote relay. Go to the elevator on the left and ride it to the lower level.

Weapon Parts 1/1 - Between crates on the scaffolding on the right side of the shuttle.

Once you get down, repel Necromorphs' attacks and then head to the leader - first part of the module [Remote Circuit Board] can be found on the shelf on the left.

Go back up, watching out for another wave of Necromorphs. Use a gondola to get to the other side of the shuttle. You can use advantage of your current position and shoot monsters which appear on the other side.

Go again to the elevator and ride it down to the lower level. The next part [Remote Radio Controller] can be found on the machine in front of you.

Go to the left and climb up a bit - the last part [Remote RAS Locator Module] is also located on the inoperative machine.

Return to the cargo elevator go ride it up. You should see a bench in front of you, where you can combine parts you've just found into a working module.

Go to the gondola and ride under the shuttle hull. Use kinesis to open the nose and install there a remote relay.